© 1995 - 2018 Family Technologies
Created by Family Technologies, using Xara
QZap
Quad frequency parasite zapper
How does it work?
The QZap produces a set of 4 simultaneous low voltage square wave
frequencies. These are combined to produce a complex waveform with an
effectiveness greater than the sum of its parts. The square wave output can
sometimes be felt by persons with sensitive skin. According to studies
performed by Dr. Hulga Clark, these frequencies are lethal to a wide range
of parasitic organisms.
Simple to use
Just plug in the AC power adapter, attach the wrist-cuffs, connect the red
and black leads and turn on the power switch. Normal use is active for 10
minutes, then a 20 minute off time; repeat 3 times.
Wrist-cuffs or other devices
Some other zapper type products have hand-held bar electrodes, or a foot
bath, or pads. While we have chosen to provide the wrist-cuff electrodes for
ease-of-use and to minimize inconvenience, if you have other electrodes
you can attach them to the standard banana leads of the QZap to get the
benefit of the conjoined frequencies.
Battery or AC adapter
You can use the QZap with the included 9V batteries, or AC Adapter. The
green power LED will turn to red if the battery voltage is too low. In that
case you must replace them or switch to the AC power adapter. The output
power is somewhat greater when using the AC adapter.
Package Contents:
•
QZap controller
•
Red / Black banana leads and clips
•
2 Wristcuffs
•
AC power adapter
•
2 - 9V batteries
•
Quick Start Guide
Comfortable wristcuffs let you keep
reading or doing desk work while
using the QZap.